Inflatable Floating Marine Airbags for Ship Launching

Nanhai Airbag Inflatable Floating Marine Rubber Airbags for Ship Launching Landing

Inflatable Floating Marine Rubber Airbags Infomation

Marine airbags are widely used for ship launching, heavy transportation and marine salvage nowadays. Marine airbags are often called ship launching airbags that indicate the most popular application of these heavy duty airbags is for ship launching. It is estimated that more than 80 percent new built ships who’s DWT below 60,000 are launched by marine airbags.

Marine airbags are found to be powerful and versatile tools for many other marine projects such as disembarking ships, heavy transportation, re-floating salvage etc. But how to select suitable marine airbags for a specific project? Let us see suggestions from a professional marine airbags manufacturer and engineering company.

Airbags Used In Marine Launching Specifications:

1. Calculated prepare enough rolling the balloon and the balloon and the traction winch, air compressor, etc.Should be subject to no-load inflatable balloon before using detection (inflation pressure is 1.25 times the safe working pressure), found that after the leakage phenomenon should be repaired in use.

2. Arrange the ship after the road, including berth to ramp.Must level off, remove impurities, pay special attention to hard nails on the ground, with a mouth stones must dig clean, prevent punctured balloon, ramps should have enough length and depth in the water.

3. Will all the outstanding Angle on the bottom plate, beauty and stern castings such as burr should be smooth.

4. The traction winch Wire Rope hull.

5. Close all sea valves, fixed the rudder and propeller.

6. Dismantle all block, fill in the rolling airbags

7. Adjust the gasbag internal pressure, make the bottom down to the appropriate work height, don't touch the ground, keep moving ship process generally small boat desirable between 0.2-0.3m.

8. All the airbag should be aimed at hull center respectively, and the vertical direction of water

9. Start the traction winch slowly released cables from hull began to move, when the first a bag from the top bottom immediately after carried to the tail, and put in the book bag planned spacing feeding airbags.

10. Repeat the above process, and gradually move the boat to the water, when not feeding balloon blockade river barred to ship.

11. Relocated, inform the staff on board ready, when the condition such as water depth enough, ordered the wire rope or decoupled fast launching ship.If the river is very narrow water fast enough, can use slow winch cable, let the boat slowly into the water.

12. Is necessary for some of the larger ships, should install slide device.

13. Recycle bag

NANHAI AIRABG

NANHAI AIRBAG Management system is ISO9001: 2000 certified and complys with all demands of the ISO 14409: 2011 standard ( For ship launching airbags) during manufacturing procedure . NANHAI AIRBAG guarantees excellent quality and performances of all products. Customer requirements are strictly followed during all production phases. His quality control department performs a true procedure control of the material and products.

Contact us if you need more details on Marine Airbag. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Marine Salvage Airbags、Ship Launching Airbag. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Marine Airbag > Ship Launching Airbag